Pentair - Clean & Clear Plus - Cartridge Filter - CCP320
[Pentair - 160340]

Pentair - Clean & Clear Plus - Cartridge Filter - CCP320

PENTAIR

Clean & Clear® Plus Cartridge filter

Model - CCP320

Crystal Clear Water the Easy Way The Clean & Clear Plus filter combines top-end filter performance with low maintenance. This dependable design uses special filter elements to strip tiny particles from your pool water…particles as small as 20 microns (an average grain of beach sand is 1,000 microns). Our four-cartridge design provides maximum filter surface area to capture more dirt and extend time between cleanings. And cleaning is a snap—open the top, remove the cartridges, hose them off and the Clean & Clear Plus filter is ready to go again. We’ve maximized cartridge surface consistency to block and trap the maximum amount of solids, plus we use the most durable materials to extend cartridge life. The Clean & Clear Plus filter delivers commercial-grade performance that keeps pools clean and sparkling, day in and day out. • Four-cartridge design traps more dirt and extends time between cleanings. • Cartridges are easy to remove and rinse. • Clamp ring allows easier access to cartridges and internal parts to speed service routines. • 1½” drain is easy to access and located to ensure complete draining during winterization. • Fiberglass-reinforced polypropylene tank is strong and corrosion resistant for extra long life. An Eco Select® Brand Product The Eco Select brand identifies our“greenest” and most efficient equipment choices. Water flows very efficiently through the Clean & Clear Plus filter, often allowing the use of smaller pumps or lower pump speeds to minimize energy use. And when you rinse cartridges rather than backwash, you can significantly reduce water use, too.

Four Cartridges in a Compact Design Clean & Clear Plus filters contain four polyester cartridges that hold enormous amounts of dirt, yet are easier to clean. The fiberglass-reinforced tank halves are secured with an innovative clamp ring—just loosen the ring and remove the top half for easy cartridge access and rinsing. Filter maintenance doesn’t get any easier. • Continuous internal air bleed helps prevent air build-up to keep the filter operating at peak performance. • Single-piece base and body for strength, stability and years of dependable service.

FIBERGLASS REINFORCED POLYPROPYLENE TANK

Clean & Clear® Plus Cartridge Filters have a corrosion resistant injection molded filter tank featuring superior strength and reliability. The cartridge assembly uses four easy to clean, non-woven, polyester cartridges. Each filter is supplied with a bulkhead union set for easy installation.

FEATURES

  • NSF listed

  • Superior strength

  • Large filter area for increased dirt capacity

  • 1-1/2 in., 100% drain clean-out port

  • Continuous High Flow internal air relief*

  • Base and plumbing kits now available

  • Injection molded tank

  • Balanced hydraulic flow

  • Tension Control clamp

  • 100% factory tested

  • Black bulkhead unions

  • High Flow manual air relief valve

Note: Actual system flow will depend on plumbing size and other system components. 
Note: Pentair Pool Products does not recommend flow rates above 150 GPM. 
*Integrated Continuous High Flow internal air relief is operational only when there is unobstructed flow in the circulating system. 
Operating Limits - maximum continual operating pressure of 50 PSI. Pool.spa (bather) applications, maximum operating water temperature (internal filter) 104 degrees F (40 degrees C)

 

 

Flow Rate2

Flow Rate3

Turnover Capacity (In Gallons)

Model

Effective Filtration Area (Sq. Ft.)

GPM Res.

GPM Comm.

8 Hour

10 Hour

12 Hour

CCP240

240

90

90

43,200

54,000

64,800

CCP320 1

320

120

120

57,600

72,000

86,400

CCP420 1

420

150

150

72,000

90,000

108,000

CCP520 1

520

150

150

72,000

90,000

108,000

 

Schedule Your Pool Filters Replacement Installation

$999.00

Reviews

Categories